-
USAMP Subtask Reports
USAMP subtask reports -
USAMP Final Report
USAMP final report -
Uniaxial Tension Testing and FLC Testing at 200C and Three Strain Rates of Mg...
This dataset has no description
-
Solution strengthening predictions
Summary of our solid solution strengthening calculations, along with expressions that can be used to predict yield stress changes for (10-11) compression twinning (CT1) edge... -
Technical Cost Model Results for Steel vs Mg Door Designs by Camanoe
Camanoe technical cost model comparing Mg door design to baseline steel door design. Includes cost drivers and sensitivity analysis. Mg door model is E-Form Plus with... -
Task 7 Final Presentation
This dataset has no description
-
Plane Strain Testing (for FLC0) at Warm Temperatures of Mg eForm Plus Batch-1
Plane Strain Testing (for FLC0) at Warm Temperatures of Mg eForm Plus Batch-1 -
Final Report
Updated Final Report -
Summary of numerical problems during mesh regularization for MAT233 calibration
Document explains the various numerical problems that were encountered during mesh regularization and calibration of MAT233 -
Compression 200C Mg e-Form Batch-3 (M12_UC-200C)
Compression 200C Mg e-Form Batch-3 (M12_UC-200C) -
Compression RT Mg e-Form Batch-3 (M12_UC-RT)
Compression RT Mg e-Form Batch-3 (M12_UC-RT) -
Shear Testing @ 200C Mg e-Form Batch-3 (M12_SH-200C)
Shear Testing @ 200C Mg e-Form Batch-3 (M12_SH-200C) -
PneumaticBulge 200C Mg e-Form Batch-3 (M12_BBT(PB)-200C)
PneumaticBulge 200C Mg e-Form Batch-3 (M12_BBT(PB)-200C) -
Shear Testing @ RT Mg e-Form Batch-3 (M12_SH-RT)
Shear Testing @ RT Mg e-Form Batch-3 (M12_SH-RT) -
UniaxialTension PreStraining Mg e-Form Plus Batch-3 @ 200C (M12_UT PreStraini...
UniaxialTension PreStraining Mg e-Form Plus Batch-3 @ 200C (M12_UT PreStraining-200C) -
HydraulicBulge RT Mg e-Form Batch-3 (M12_BBT(HB)-RT)
Hydraulic Bulge RT Mg e-Form Batch-3 (M12_BBT(HB)-RT) -
Plane Strain Testing (for FLC0) at Warm Temperatures of Mg eForm Plus Batch-3...
Plane Strain Testing (for FLC0) at Warm Temperatures of Mg eForm Plus Batch-3 (M12_PST-FLC) -
Final Report
Cross form stamping test was done at different temperatures to assess formability of magnesium using different pretreatments and lubricants. -
FADI-AMT_UniaxialTension RT Mg e-Form Plus _ Comparison between Batch-1 and B...
Uniaxial tension test at room temperature to measure the stress and strain to compare batch-1 and batch-3 Magnesium EFORM Plus Sheets.