-
Simulation input, output, visualization scripts, and visualizations created f...
Polycrystal models binary allows of MgSn and MgCa. Input geometries and meshes were generated using Neper. Input orientations were generated using MTex in Matlab. Simulations... -
Crystal plasticity-based simulation of cross-forming
Simulations of cross-forming with crystal plasticity for EFORM+ Batch#1 at constant temperature and strain rate (200C, 0.01s-1) -
CALPHAD calculation of Alloy 2
CALPHAD prediction of solidification microstructure and diffusion simulation in Alloy 2. -
Mixing enthalpy of various equiatomic pairs in Mg (hcp) matrix
Calculation of mixing enthalpy of various equiatomic pairs in Mg (hcp) matrix -
Diffusion modeling of solutes in Alloy 2 plus
Diffusion modeling of solutes Al, Zn, Ca, Ce and Mn in Mg (hcp) using DICTRA software -
CALPHAD prediction of solidification microstructure
CALPHAD prediction of solidification microstructure and optimized thermomechanical processes for producing ZAXME11100 sheet alloy -
Input for Material Card 233+
This file is the inout deck for Material Card 233+ that is calibrated for Batch 1 at 200oC and 0.1s-1. -
Summary of numerical problems during mesh regularization for MAT233 calibration
Document explains the various numerical problems that were encountered during mesh regularization and calibration of MAT233 -
Simulations of various strain paths with crystal plasticity for Batch_ONE
Crystal plasticity simulations (for Batch_ONE at 200oC) of: - Balanced biaxial tension - Uniaxial compression along RD - Plane strain tension along RD and TD - Simple shear... -
Simulations of various strain paths with crystal plasticity for Batch_THREE
Crystal plasticity simulations (for Batch_THREE at 200oC) of: - Balanced biaxial tension - Uniaxial compression along RD - Plane strain tension along RD - Simple shear along RD... -
MAT233 for Batch_ONE
MAT233 material cards calibrated for Batch_ONE material at 150oC, 200oC and 250oC for 0.1s-1 and 0.5 s-1 strain rates. Mesh regularization performed for 6mm, 3mm and 1.5mm mesh... -
MAT233 for Batch_THREE
MAT233 material cards calibrated for Batch_THREE material at 200oC and 0.1s-1. Mesh regularization is performed for 6mm, 4mm and 2mm mesh sizes. -
FLDs for Batch3 @ 200oC with and without pre-strain
FLD simulations with crystals plasticity -
FLDs for Batch1 @ 150oC, 200oC and 250oC
FLD predictions with crystal plasticity